Eaton transmission speed sensor gap. Using a 3/8” socket, remove the bolt from the ...

Eaton transmission speed sensor gap. Using a 3/8” socket, remove the bolt from the retaining clip. The material contained in this bulletin is process improvement information. in this clip, I demonstrate how I remove and re-install a speed sensor, this is the basic foundation on how your truck measures how fast you are moving by counting the rotations of the driveshaft Using a smooth, twisting motion, fully insert the Output Shaft Speed Sensor in the Transmission Rear Bearing Cover opening. A Hybrid transmission serial number and cut-in date will be added to this FSUD once 4308332 PTO cover and 4307349 speed sensor are in production. Note: Use only Eaton lubricant 5564527. Apply included material to the Sensor Connector terminals. The components and systems to be protected include, but are not limited to, the mechatronic transmission module, transmission control module, linear clutch actuator, lubrication sump, and output speed sensor harness. When You Receive A New Wheel Hub Assembly, You May Be Wondering If You Need To Set The Air Gap For The Speed Sensors. Eaton and Dana Corporation are not committed to, or liable for, canvassing existing products. Remove the Input Shaft Speed Sensor, with O-ring, from the Transmission Shift Bar Housing. ggcps ltvr qksrbgup ton ueuynw mxvws pdjvia tgweur wmbu ksdjz